MAIL


Restricting mail routing based on message size
You can set size limits on messages to prevent large messages from consuming network bandwidth. There are two types of message size limits: a maximum message size and a low-priority size range. Messages that exceed the maximum message size are returned to the sender as undeliverable. Messages that are smaller than the maximum size, but that fall within the specified size range, are marked low-priority and routed during off-peak hours (12 AM to 6 AM by default).

IBM® Lotus® Domino® uses the maximum message size you specify as the upper limit of the low-priority size range. Before specifying a low-priority size range, you must set a maximum message size.

The size restrictions you set in the Configuration Settings document apply to every message the Router handles, regardless of whether the message is inbound or outbound, routed over IBM® Lotus® Notes® routing or over SMTP. To set a unique size limit on some part of your messaging traffic, you must set up distinct routing paths for that traffic and then create separate Configuration Settings documents for servers on those paths. For example, if you want to place a 500KB limit on inbound SMTP mail and a 1000KB size limit on internal mail, create two Configuration Settings documents: one for the servers that receive mail from the Internet that specifies a 500KB size limit and a second for your internal mail servers that specifies a 1000KB limit.

To set message size restrictions

1. Make sure you already have a Configuration Settings document for the server(s) to be configured.

2. From the IBM® Lotus® Domino® Administrator, click the Configuration tab and expand the Messaging section.

3. Click Configurations.

4. Select the Configuration Settings document for the mail server or servers you want to administer, and click Edit Configuration.

5. Click the Router/SMTP - Restrictions and Controls - Restrictions tab.

6. Complete these fields in the Router Restrictions section, and then click Save & Close:
FieldEnter
Maximum message sizeThe maximum message size in KB (thousands of bytes) the server accepts. The Router rejects any messages that exceed this size for both transfer and delivery. The default is 0 KB, which does not limit message size.
Send all messages as low-priority if message size is betweenChoose one:
  • Enabled
  • Disabled (default)
If you choose Enabled, specify the lower limit of the size range in KB. By default the lower limit is 50KB. The upper limit of the size range is defined in the field Maximum message size. When enabled, messages with a size between the value entered in this field and the value in the Maximum message size field are sent as low-priority messages.
7. The change takes effect after the next Router configuration update. To put the new setting into effect immediately, reload the routing configuration.

Related topics